Page 1 of 1

EIGRP and IP-address Helper

PostPosted: Mon May 20, 2013 6:39 am
by ivan
Hi Sir

if i have 3 router , R1,R2,R3 run EIGRP AS 1 and R1 connect with server DHCP and R3 connect with switch and DHCP client . pls advise how configure with IP address helper ?

Re: EIGRP and IP-address Helper

PostPosted: Sun Dec 15, 2013 1:47 pm
by harvinder
Hi...
You need to configure the R3 router inside interface which is connected to switch with IP Helper Address command (DHCP Relay) and complete that command by adding R1 ip address (which is connected b/w R1 & R3).
Now when the R3 inside interface receives the broadcast packet for DHCP server theny by the help of DHCP relay it forward that packet to the R1 where DHCP server is connected as unicast packet.

Re: EIGRP and IP-address Helper

PostPosted: Mon Mar 12, 2018 2:25 am
by hugow
Configure the R3 router inside interface and complete that command by adding R1 IP address

Re: EIGRP and IP-address Helper

PostPosted: Sat Apr 28, 2018 1:21 am
by armxx048
hugow wrote:Configure the R3 router inside interface and complete that command by adding R1 IP address


If you have any problem related to router loginor regarding configuring your router. check this blog https://10-0-0-0-1.org

Re: EIGRP and IP-address Helper

PostPosted: Mon Jun 25, 2018 3:49 am
by nanataha
If there are many sad stories, share it with the people you trust. Sharing helps people get closer together and you also relieve some of that sadness.